FSBUS Servo problem
 

Hello

I have now build the FSBUS servo, and have som problem.

I can write to the PIC without any problem, but i can nor run the servo.

Nothing happens when i connect a servo, and try to move it.

I have a mail from Dirk. He says that it can be the servo.

I have try with Hitec, Multiplex and Futaba servo, bot no of them have function.

Have any have the same problem, and witsch type of servo are you using.

PS.
I have also FSKEY and FSDO, its running without any problem.

Regards

Finn
Denmark

Hi Finn,

are you able to test the servo control signal with a scope?
I am using Conrad servos of type "CARSON". That are low price types.


regards Dirk

Hi Dirk

I dont have a scope, I have to try to borrow one next week.

Regards
Finn

Hello again Dirk

To be sure, i write to the PIC one more time.

And now the servo controler have full funktion, somthing must be happen when i wrote to the PIC first time.

But now it funktion very good, and now i will start to build some instruments.

Regards
Finn

Good luck Finn,

if you have built one of them, i am very interested about your experinces.

regards Dirk