Hi as promised here the part you need to put into your fsif.ini file to get the PM ecam select buttons to work with FSbus.

0, "PMSYSTEMS ECAM SELECT"
1, "ENG", 600, 0, 0x552C, I32,,RW ,10,1,1,
1, "BLEED", 601, 0, 0x552C, I32,,RW ,10,1,2,
1, "PRESS", 602, 0, 0x552C, I32,,RW ,10,1,3,
1, "ELEC", 603, 0, 0x552C, I32,,RW ,10,1,4,
1, "HYD", 604, 0, 0x552C, I32,,RW ,10,1,5,
1, "FUEL", 605, 0, 0x552C, I32,,RW ,10,1,6,
1, "APU", 606, 0, 0x552C, I32,,RW ,10,1,7,
1, "COND", 607, 0, 0x552C, I32,,RW ,10,1,8,
1, "DOOR", 608, 0, 0x552C, I32,,RW ,10,1,9,
1, "WHEEL", 609, 0, 0x552C, I32,,RW ,10,1,10,
1, "F/CTL", 610, 0, 0x552C, I32,,RW ,10,1,11,

Just pay attention to the numbers 600 until 610 that they not already used by you then change them to a unic number.

After that startup your fsrouter and make a button then at option to it by select the dropdownlist. You will see then a subject PMSYSTEMS ECAM SELECT open that one and you see each button standing. Choose 1 and hit OK.

Make sure your down value is 1 and up value is 0

Then you can test the button when running the FS and PM ABGC + Lower ecam running.

Have tested it here with and without PMsystems and works fine.

succes

gr.

Frans M

Thank for your Help,
it works !! Wery fine !!

und danke an diejenigen die mir hier genarwortet haben,
es klappt.

Super und nun bin ich wieder ein Stück näher an der realität

Mit freundlichen grüßen
Stefan

http://www.A320-232Simulator.de

Your Welcome :)

Glad i could help you out on this one.

gr.

Frans M

Hi Frans,

seems you are a great expert in programming. Have a question on PM together with FSBus:
I´m trying to use the PM offset x5428 (available in FSIF.ini as PM "CDU keyboard interface). This should allow to send the ASCII characters directly to the CDU. (This could avoid the CDU always having the focus)
How do I have to extend the FSIF.ini in order to get those ASCII char.
transmitted.

Thanks a lot in advance.

Best regards

Peter

Hallo,


Wenn ich im FS9 die Türen öffne ,
wird dies nicht auf der Projekt Magenta EICAS
DOOR/Oxygen PAGE übermittelt,
funktioniert das bei irgendjemand ??

Grüße
Stefan

Realize Your Dream
www.A320-232Simulator.de

Hallo Stefan,

ich denke mal Du wirst dazu die Systemsoftware benötigen. Ansonsten mal bei Enrico im Forum fragen.


Gruß

Peter