WCM Forum - FSBUS: 2 Keycards on bus problem!

WCM Forum (http://www.wcm.at/forum/index.php)

- Home Cockpit - Das Forum für die "Bastler" (http://www.wcm.at/forum/forumdisplay.php?f=55)

- - FSBUS: 2 Keycards on bus problem! (http://www.wcm.at/forum/showthread.php?t=166258)

Zitat:

Original geschrieben von dirkan
Hi Ole,

it seems to be a signal problem.

You can try following changes:
COM R3 1K: try a 10k instead

Another try:
leave the controllers connected, but disconnect the key cables from the working controller. Then test, if the problem on the other controller remains.

Let's see what happens.

Dirk

Thanks for your help, Dirk!
I have tried both your suggestions but the problem is exactly the same. Replaced the 1k on the COM3 card for a 10k, and disconnected all the KEy wires on the working controller (ID4). Any more suggestions? Can something be faulty on the ID3 key card even if it is working when the ID4 Keycard is disconnected from the bus (I have also replaced the PIC on the ID3) ?

Hi,
I've had 4 Key Card and the same problem with ID 4, always when I connected Key Card 4 the Key event was at all Cards only hasitantly or sometimes not recognized. I searched the reason at the connectors, bit I didn't find. After I flashed the 4th Key card on ID 5 the problem was lost. So I suppose the problem is based at ID 4.
I hope this could help you.

Gruss
Dirk